Corn Pollination and Grainfill (2024)

Corn Pollination and Grainfill

Each year as corn growers scout fields after pollination to assess the size of their crop, certain areas may find evidenceof uneven pollination or aborted kernels at the tip of ears. These are caused by different factors, and the severity willvary from year to year.

While there isn’t a way to regain the lost potential, understanding the cause can help you make managementdecisions to prevent it in future years. And an accurate assessment of yield potential will help you more effectivelyplan for harvest, grain storage and grain marketing.

A critical time

Pollination is a very important time for a corn plant, and it requires a lot of water and nutrients to maintain high yield potential. After pollination, the corn plant switches nearly all of its resources to filling kernels, commonly referred to as the grain fill period. Plant health is critical during grain fill, and healthy leaf tissue, especially from the ear leaf up, is needed to maximize yield. Healthy roots are needed to intake essential water. And healthy stalk tissue is needed to transport sugars, water and nutrients and to structurally support the developing ear.

Stress on corn plants during pollination and grain fill can cause incomplete or sporadic pollination as well as ear tip die back. The timing and severity of the stress will determine the extent of the effect on yield potential. Incomplete pollination and ear tip die back can easily be confused. As you can see in the picture above they look similar, but are caused by stress at two very different times. To better understand each critical time we’ll look at some potential causes of stress during both pollination and grain fill and the effect they may have on the plant.

Corn Pollination and Grainfill (1)

incomplete pollination

Sporadically pollinated ears have a normal size cob and appear full in diameter, so it won’t seem apparent until more intense scouting is done. Poor pollination occurs most often when silk emergence is not synched with pollen shed. It can be caused by many environmental factors such as heat, drought, excessive water, nitrogen deficiency, lack of sunshine, seedling disease, herbicide damage or compaction.

Corn Pollination and Grainfill (2)

ear tip die back

Tip die back occurs when the plant senses there aren’t enough resources to fill all kernels set on the ear, causing it to abort kernels at the tip to concentrate energy on filling the remaining kernels. As you’ll see from the table below, potential for yield loss depends greatly on the timing of stress during grain fill. If this occurs early in the grain fill period it is difficult to distinguish aborted kernels from non-pollinated kernels. Silks will remain attached to kernels that weren’t pollinated for a few weeks. Regardless, the end result of an aborted kernel is the same as a non-pollinated kernel: Yield loss.

Corn Pollination and Grainfill (3)

Many of the same stresses that can cause incomplete pollination will also cause ear tip die back if they happen during grain fill. Stresses like drought stress, excessive moisture, disease, and high night temperatures (over 70⁰ F) can all lead to ear tip die back. In addition to those, there are a few more factors that could lead to the loss of ear tip kernels.

Consecutive cloudy or overcast days – Photosynthesis is slowed in low light intensity which limits the amount of sugar availability for developing kernels.

Variable seedling emergence – Late emerging plants are at a competitive disadvantage to their neighboring early emerging plants. The late plants will often have smaller ears with more tip back.

High plant population – Higher plant populations increases plant competition for light, nutrients, and water. A small amount of tip back is not necessarily a bad thing if the kernels lost at the ear tip is compensated by more ears per acre.

Large kernel set –In years with ideal conditions from V6 to tassel, corn will establish a large number of potential kernels to fill. If the plant senses that it is not able to provide the necessary resources to fill a large potential kernel number, it will pull back the kernels at the tip of the ear. In situations where plants aborted some kernels at the tip but kernel length is still 30 to 35, yield potential is still very high. Varying degrees of ear tip back.

Conclusion

Pollination and grain fill are very important times in a corn plant’s life cycle, and stress on the plant during ear development and pollination can have a serious impact on final yield. Some causes are environmental and out of your control, but others can be prevented. Keeping the plant healthy is important going into the pollination and grain fill period. Identify the cause of issues found so that you can take action to prevent them in the future.

Corn Pollination and Grainfill (2024)

FAQs

How much corn is needed to pollinate? ›

Even two rows of corn will not pollinate correctly. A plot 4 feet long by four rows wide is the minimum to getting good full ears of sweet corn. Sometimes you can get by with three rows. The photo shows what happens when only two rows of corn are planted side by side.

What is the pollination method of corn? ›

Pollination is achieved when pollen grains from the tassels above contact the silks at the nodes. Two methods of pollen transfer may be used with corn. Cut an entire tassel, and use it as a wand, shaking pollen grains (dust) onto the silks.

What is needed for a corn plant to be well pollinated? ›

Corn is typically pollinated by the wind, having both male (tassels) and female (silks and ear) flowers. Pollen from the tassels needs to land on the silks in order to create a good crop.

How long after pollination is corn ready? ›

When to Harvest
Kernel Growth StageDays After Pollination
Dented40
Late Dent45
Half Milk Line50
Mature55
7 more rows
Jul 18, 2022

How long after tassel does corn pollinate? ›

All the anthers on an individual tassel may take as long as seven days to finish shedding pollen, although the greatest volume of pollen is typically shed during the second and third day of anther emergence.

What happens if you plant corn too close together? ›

Corn is a hungry plant, so it's important to enrich beds with lots of organic matter such as garden compost then follow this up at planting time with a scattering of a balanced general purpose organic fertilizer. Don't plant too close together or you run the risk of disappointingly small cobs.

Do you need 2 rows of corn to pollinate? ›

To insure good pollination and ear development, plant several short rows or blocks rather than 1 or 2 long rows. Inadequate pollination results in poorly filled ears. Since different types of corn can cross-pollinate and contaminate one another, they should be isolated from each other.

Does rain affect corn pollination? ›

Natural field variability causes pollen shedding to occur over a 10 to 14-day period. Peak pollen shed is usually mid-morning, but a wet anther will not shed its pollen. Weather that is cooler, cloudy or humid will delay pollen shed, and shedding will not occur during rainy conditions.

How can I improve my corn pollination? ›

When planting corn, it is important to plant at least three rows side by side to ensure adequate wind pollination. The female flower, or silks, are threadlike projections from the actual ear or cob of the corn. Each thread or silk represents an individual kernel on that particular ear of corn.

What time of year does corn pollinate? ›

Most corn hybrids tassel and silk about the same time although some variability exists among hybrids and environments. On a typical midsummer day, peak pollen shed occurs in the morning between 9:00 and 11:00 a.m. followed by a second round of pollen shed late in the afternoon.

Why destroy male corn? ›

Destroying the stalks prevent them from sucking up water and nutrients from the female plants. Eliminating the male rows lowers the chance of volunteer corn — the result of stray seeds sprouting in the spring. And it also avoids a sorting nightmare come harvest season.

Why is my corn not pollinated? ›

Poor pollination occurs most often when silk emergence is not synched with pollen shed. It can be caused by many environmental factors such as heat, drought, excessive water, nitrogen deficiency, lack of sunshine, seedling disease, herbicide damage or compaction.

What happens if corn does not pollinate? ›

With inadequate pollination you are likely to get cobs that are only partially pollinated and hence look misshapen and uneven. You should still get cobs - but the may be less appealing for the table. Charles Kleff wrote: If you plant that many plants, you will get corn but you will not want to save seeds.

What happens if corn self pollinated? ›

If one of the progeny plants is self-pollinated, the new progeny again differ from each other and from the parent plant, but the degree of the difference is not as great as occurred after the first self-pollination. If this process is repeated about seven times, then a plant known as an inbred is produced.

What happens if corn is not pollinated? ›

What you're describing is poor pollination. On an ear of corn, each silk has the potential to become kernel, and silks that go unpollinated will not develop into kernels, leaving all those empty spots on an ear of corn.

Will my corn pollinate itself? ›

While corn can pollinate itself, around 97 percent of the silks on a plant are pollinated by neighboring plants, so if we were to plant in a row the opportunity for the silks to intercept pollen of any kind would be dramatically reduced. Plant your corn around 14-16 inches (35-40cm) apart in both directions.

Does rain help pollinate corn? ›

Prolonged wet and cloudy conditions prior to silking and through the early reproductive growth stages can reduce pollination and yield potential. wet weather it is not the only stress that can cause pollination issues. Poor timing of pollen shed (anthesis) and silk emergence can also lead to reduced seed set.

Should you irrigate corn during pollination? ›

Corn water use peaks during the early reproductive stages. Water stress should be avoided during tasseling, silking, and pollination. Water stress during silking can have the greatest impact on yield potential due to desiccation of the silks and pollen grains, which can result in poor pollination.

Top Articles
Latest Posts
Article information

Author: Sen. Emmett Berge

Last Updated:

Views: 5924

Rating: 5 / 5 (60 voted)

Reviews: 91% of readers found this page helpful

Author information

Name: Sen. Emmett Berge

Birthday: 1993-06-17

Address: 787 Elvis Divide, Port Brice, OH 24507-6802

Phone: +9779049645255

Job: Senior Healthcare Specialist

Hobby: Cycling, Model building, Kitesurfing, Origami, Lapidary, Dance, Basketball

Introduction: My name is Sen. Emmett Berge, I am a funny, vast, charming, courageous, enthusiastic, jolly, famous person who loves writing and wants to share my knowledge and understanding with you.