5 Ways to Clean Hard Water Spots Off Windows - wikiHow (2024)

Explore this Article

Co-authored byMichelle Driscoll, MPH

Last Updated: August 6, 2023Approved

ARTICLE

VIDEO

Download Article

1. 1

   Fill a squirt bottle with half water and half vinegar. The best vinegar to use is plain white distilled vinegar, which is inexpensive and effective. A higher concentration of vinegar may be even more effective, so adjust the vinegar to water ratio based on the severity of the water spots.

2. 

   2

   Spray the vinegar solution on the glass. Spray the solution on the glass, being sure to fully saturate any stubborn water spots or areas of concentrated buildup. Allow the vinegar to soak, and reapply a couple of times for particularly dirty areas.

   Advertisem*nt

3. 

   3

   Saturate a towel with the vinegar solution. Soak a rough towel in vinegar and water, and spread it over the sprayed area of glass. You can allow the towel to sit over the area so that the vinegar can soak in thoroughly.

4. 

   4

   Scrub the glass lightly with the towel. Use your rough, soaked towel to scrub the glass. You should not have to scrub hard. The bumps on the towel should act as an abrasive to help remove the spots and allow the vinegar to penetrate the mineral build-up.

5. 

   5

   Allow the vinegar solution to sit. The worse the stains are, the longer the vinegar will need to do its work. Let the vinegar soak in, and reapply if it seems to be drying out.

6. 

   6

   Remove the vinegar solution with a dry towel or squeegee. You may want to spray the area once more with your vinegar solution or plain water, then towel off with a clean, dry towel (or paper towel) or use a squeegee to remove the water. Be sure you do not allow the vinegar solution or water to dry on the surface of the glass, as this will continue to leave more spots.

Advertisem*nt

Download Article

1. 

   1

   Use lemon juice instead of vinegar. Lemon juice has the same acidic properties as vinegar, and can be equally as effective. Fresh lemon usually works better than bottled lemon juice.

   • Try rolling the lemon on a hard surface with some pressure before cutting it open. This will make the lemon easier to juice.
   • Squeeze the juice out of a lemon and place in a spray bottle with water or use a towel to apply the lemon juice to the glass.
   • Alternatively, you can use the lemon itself on the surface of the glass. Just cut the lemon in half and rub the open area on the glass with a fair amount of pressure.
   • Allow the lemon to soak in, then remove from the glass using water or a traditional glass cleaner.
2. 

   See Also

   How to Remove Hard Water Stains from Commercial GlassHow to Get Rid of Stains with Vinegar? Does it work for REAL?Dawn Dish Soap Cleaning - One Organized MomWhat You Should Know About Cleaning with Vinegar

   2

   Try lemon or orange essential oil. Essential oils are becoming increasingly popular due to their rumored health and cleaning benefits. Citrus-based essential oils such as lemon and orange may remove hard water deposits. This has an added benefit as well: the oil tends to serve as a water repellant and may prevent future spot buildups.

   • Place several drops of the oil in water, and use a sponge or a towel to apply the solution to the glass.
   • Allow to soak, then scrub lightly with the towel or sponge.
   • Remove from the glass using water or a traditional glass cleaner.
3. 

   3

   Apply white toothpaste to the area. As strange as this may sound, toothpaste is made to remove build-up, so it works fairly well on hard water spots.

   • Water down the toothpaste with some water so that it spreads more easily and so that you can use less toothpaste.
   • Apply the paste to the glass and allow to sit.
   • Scrub lightly with a brush, a towel, or a sponge.
   • Wash the paste away from the glass with water.
   • Clean the glass with water or a traditional glass cleaner, but be sure to dry it thoroughly so that the water spots do not re-form.
4. 

   4

   Make a paste of baking soda and vinegar. The paste will bubble when you combine the two. You can wait for the bubbling to subside or you can apply the still-bubbling paste directly onto the glass. Do not combine vinegar and baking soda in a closed container, as the resulting gas expansion may cause the lid to forcibly fly off.

   • Apply the paste to the glass and allow to sit.^[1]
   • Scrub lightly with a brush, a towel, or a sponge.
   • Wash the paste away from the glass with water.
   • Clean the glass with water or a traditional glass cleaner, but be sure to dry it thoroughly so that the water spots do not re-form.

Advertisem*nt

Download Article

1. 

   1

   Find a powdered abrasive cleaner. Some abrasive cleaners are Comet, Barkeeper’s friend, or simple baking soda.^[2] These are all powdered cleaners that can be sprinkled on a surface area.

2. 

   2

   Wet the surface of the glass. It is easiest to wet the glass first, then apply the powder to it. This way, the powder will stick to the surface of the glass. The water and the abrasive will work together to make a sort of cleaning paste.

   • For extra cleaning power, use straight vinegar or a 50/50 mixture of vinegar and water to wet the glass.
3. 

   3

   Apply the powdered cleaner to the glass. Many purpose-made powder cleaners have multiple holes in the top that facilitate sprinkling. If yours doesn’t, or if you’re using baking soda, you could try putting the powder in a small sifter and sprinkling it on the surface with that.

4. 

   4

   Use some “elbow grease.” The major benefit of the abrasive cleaners is the micro-scrubbing action provided by the granules of the cleaner.^[3] In order for these granules to work, you will need to apply some vigorous scrubbing. Think of it as a double benefit: cleaning and a workout at one time!

5. 

   5

   Rinse the product away with water. While some cleaning products can be left on the glass, an abrasive cleaner is likely to leave a residue since it isn’t designed specifically as a glass cleaner. Thoroughly rinsing the cleaner away with water, then cleaning the glass with a traditional glass cleaner is the best way to ensure that the abrasive cleaner does not leave any residue.

6. 

   6

   Dry the glass. After you rinse away the cleaner and clean the glass with water or glass cleaner, be sure that you dry the surface thoroughly to prevent additional water spots.

7. 

   7

   Use a fine-grade abrasive scrubber. An alternate approach to using an abrasive cleaner is to use a fine-grade abrasive scrubber. Look for one that is marked “0000” to ensure that it will not damage your glass. The scrubber essentially works like very fine sandpaper to remove stains and build-up from the glass. Some popular abrasive scrubbers are steel wool, rough green scrub sponges, and a product known as a magic eraser, which is a very fine sponge.

Advertisem*nt

Download Article

1. 

   1

   Find a product made to remove hard water stain buildup. There are products that are specifically designed to remove hard-water spots from glass and other surfaces. You may want to try other household products first, as buying several different cleaning products for one cleaning problem can be costly. Here are a few specific products that may help with hard water spots:

   • CLR
   • Barkeeper’s Friend
   • Kaboom
   • Lime-away
2. 

   2

   Apply the product according to the directions on the packaging. Most products require being sprayed on or applied using a sponge or towel. Most products will recommend that you allow them to sit and soak in to saturate the surface of the cleaning area.

   • Some products suggest wiping them on and off, but not scrubbing them because scrubbing can lead to unwanted splatter.^[4]
   • It’s always best to test a small portion of the surface to be sure that a product will not damage it.
   • Be sure to take care to keep the product only on the glass you are cleaning: the cleaner may damage adjacent walls, window sills, tile, flooring, or car paint.
3. 

   3

   Wear some protective gear if necessary. Many cleaners are caustic and can be damaging to humans or animals. Be sure to wear gloves and protective eyewear such as goggles if necessary.

   • Wash your hands immediately after contacting any cleaner, and never put your hands to your mouth, nose, or eyes immediately after contact with cleaners.
   • Many cleaners suggest using in a well-ventilated area to avoid any bodily harm due to fumes from the product.
   • Be sure to read warning labels on the product carefully.
4. 

   4

   Clean the area with water or a vinegar solution. After using a cleaning product, you may want to clean the glass with a water or vinegar solution to remove any residue of the cleaner. Be sure to dry the glass thoroughly.

5. 

   See Also

   Remove Hard Water Dots & Calcium Deposits From Glass | Benaz

   5

   Store the products safely. Cleaning products should always be stored outside of the reach of children and pets, with the lid securely in place and any spilled cleaner wiped away from the outside of the bottle. On a high shelf behind a door with a childproof latch on it is ideal.

Advertisem*nt

Download Article

1. 

   1

   Treat water spots quickly. If hard water spots are treated in the beginning of their formation, they will be less stubborn and easier to remove. Simply spraying spots with a vinegar solution once a week or so, as they begin to form, may be adequate.

2. 

   2

   Remove any resting water. Prevention is the best way to deal with hard water spots. Not allowing water to rest on and evaporate from surfaces can be the key to preventing the spots from forming in the first place.

   • Wipe the wet glass down with a dry towel if you see water on it.
   • Use a squeegee to remove standing water from glass. This will keep your glass looking clean and clear.^[5]
3. 

   3

   Keep your windows dry. The easiest way to avoid water spots is to prevent your glass from getting wet to begin with. If you are dealing with water spots on car windows, try parking your car in a covered area, such as in your garage. Installing blinds or curtains may keep the water off of windows near kitchen or bathroom sinks.

4. 

   4

   Treat the glass with a water repellant. A product that repels water, such as an oil-based cleaner or a product such as rain-x, may help spots from forming on your glass.^[6] Do not use a product on car windows unless they are specifically made to treat car windows and will not interfere with visibility in wet or dry conditions.

Advertisem*nt

Community Q&A

Ask a Question

Video

Tips

Thanks for submitting a tip for review!

10 votes - 76%